I followed the porting guide from mmWaveLink docs and managed to run mmWaveDFP on my FPGA. I am running mmWaveLink_SingleChip_NonOS_Example and using SPI communication. MMWL_powerOnMaster and ...

I am looking to flash the program into the Flash memory of our controller using the CAN protocol. Could you kindly suggest the best approach or tools for achieving this? Additionally, I require a ...

I am currently working with the TMS320F28335 microcontroller and using the Example_2833xSci_FFDLB_int.c example code. My goal is to configure the system so that data is transmitted on the TX pin only ...

I´ve used Uniflash application to create a standalone command line package (zip) for the XDS100 v3. On another PC, I ran "one_time_setup.bat" and then "dslite.bat ...

I have a problem with the DAC output: it always stays at 0 volts. To provide some context, I designed and prototyped two bipolar voltage sources using the DAC8812 and two OPA2277 (based on the bipolar ...

Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask ...

I was finally able to load and run U-Boot. Anyway the dtb/Linux loading process keeps on failing and I fall back into U-boot console. Here's the log I get: U-Boot SPL 2024.04-dirty (Sep 30 2024 - ...

Referring to the list of clock identifiers in the link and also refer the clock summary taken from /sys/kernel/debug/clk ...

I was simulating a circuit which contains all AD parts. I found the the alternate TI parts and started simulation in tina ti . The results I obtained in both simulations are entirely different . Op ...

Hello, I have a question regarding my DSP28377D board. It has been running normally for some time, but occasionally (it has happened many times, with a probability of about 1%) the program fails to ...

My project using TDA4 VM + SDK 9.1 + EMMC boot. Emmc device type is MTFC32GASAQHD-AAT. EMMC boot is normal without special operations.But emmc boot gets stuck when I do the following operation，These ...

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?